Job NOT Done. There are warnings ... Find at

[gcampbell2000]

well. no luck. when i load the avi, it says "interface not supported"

[trustfm]

do you have the 0.4.1 version ? are you sure ?

[gcampbell2000]

I upgraded the program and it worked just fine. ty

[koden]

Hello,

I'm using VirtualDubMod version 1.5.10.1 and on following the images I get the following error:

'No audio decompressor could be found to decompress the source audio format.'

Any idea why I'm getting this? the .avi does have sound though.


koden.

[trustfm]

koden as you can seee your sistem does not have the specific audio codec just install that codec

[koden]

Thanks for your reply, but which audio codec do I need to install?

[NOOSA]

koden...

You most likely need the AC3 filter...

I used the AC3ACM v1.2 by fccHandler...google it, I forgot were I got it from. It came in the form of an RAR and the readme file explains how to install it...takes less then a minute to install.

Note: I used another AC3 filter and it didn't work, used this one and it worked...go figure. So if one AC3 doesn't work, try another.

Good luck.

Update: I found out what was causing my "jobs not done, 0 bytes" error...my pathname + file name for the output file was too long.

It looked like this:
C:\Documents and Settings\USER\My Documents\My Videos\MOVIE DESTINATION DIRECTORY\AVI2DVD_TEMP\

Once I changed it to "C:\MOVIE DIRECTORY\AVI2DVD_TEMP"...authoring was back to normal.

[koden]

Thanks for your reply but even with the AC3 codec installed as you mentioned in your post, then following the guide again I still get the error.

Here's what happens when I try to convert my movie to DVD in AVI2DVD:
[7:09:47 PM] AVI2DVD Started !
[7:09:48 PM] Type mode : Avi Input
[7:09:48 PM] Output : Dvd
[7:09:48 PM] Encoder Selected : HCEnc
[7:09:49 PM] Start demuxing the AudioStream No.1 ...
[7:10:13 PM] Demuxing of the selected audio finished successfully ! [C:\Avi2dvd_temp\Extracted_Audio.wav 146088712 Bytes]
[7:10:13 PM] Audio extracted renamed successfully ! [C:\Avi2dvd_temp\Fixed_Audio01.wav 146088712 Bytes]
[7:10:13 PM] Starts Wav->Ac3 convertion ...
[7:10:15 PM] Audio converted in Ac3 successfully ! [C:\Avi2dvd_temp\AudioStream 1 WAV 2CH.ac3 -1 Bytes]
[7:10:15 PM] Job NOT Done. There are warnings ... Find at the log file the 0 byte generated file to focus where exactly the problem appears
[7:10:15 PM] All Jobs Done !!!


I used AVIcodec to get the video and audio so maybe this will help:


File: 600 MB (600 MB), duration: 1:41:27, type: AVI, 1 audio stream(s), quality: 50 %


Video: 461 MB, 635 Kbps, 23.976 fps, 512*384 (4:3), DX50 = DivXNetworks Divx v5, Supported


Audio: 139 MB, 192 Kbps, 44100 Hz, 2 channels, 0x50 = Mpeg-1 audio Layer 2 (MP2), Supported

As for the pathname it's just C:\AVI2DVD_TEMP

Any more suggestions would be appreciated,

- koden.