I post it here again because this is the right place.....
when I try to choose (avi2dvd) 800MB CD, 2 CD's, (SVCD) and as encoder CCE and push "go" the settings are jumping back to "DVD" and to another encoder. Sometimes the settings stay sometimes not in the moment of enter "go".
CCE is found.....
settings jumping back
Moderators: george, roger_rabbit, reburn, Excalibur!, skyheartblue
I ran into this as well, but I think you can get them to stick if you do things in the right order. What I do is:
Step 1. Load your file
Step 2. Choose the disk size
Step 2. Set audio bitrate/ cue/bin selection & Pal to Ntsc (or whatever)
Step 2. ADD JOB
Step 3. Set encoding options-- any other options on Step 4 & 5...
Then GO.
I know when I first started using it, I was seeing the DISK size getting reset when I would do something (don't remember what) and I couldn't get it to stay-- I was trying to do a SVCD and it would keep going back to DVD when I set some of my other options. Finally when I did the ADD JOB at the right time (and not RIGHT after step 1) the settings wouldn't reset. I can't seem to reproduce it now because I've learned the right order to make things happen and I can't remember what I did originally, but it sounds like it could be the same problem. Keep experimenting with doing the things in a different order until you find the combination that works. Might be worth documenting *exactly* what you do and in exactly what order and then someone else can see if they can reproduce it and perhaps the problem could be fixed in a future release. I dont think it's a show stopper though...
Step 1. Load your file
Step 2. Choose the disk size
Step 2. Set audio bitrate/ cue/bin selection & Pal to Ntsc (or whatever)
Step 2. ADD JOB
Step 3. Set encoding options-- any other options on Step 4 & 5...
Then GO.
I know when I first started using it, I was seeing the DISK size getting reset when I would do something (don't remember what) and I couldn't get it to stay-- I was trying to do a SVCD and it would keep going back to DVD when I set some of my other options. Finally when I did the ADD JOB at the right time (and not RIGHT after step 1) the settings wouldn't reset. I can't seem to reproduce it now because I've learned the right order to make things happen and I can't remember what I did originally, but it sounds like it could be the same problem. Keep experimenting with doing the things in a different order until you find the combination that works. Might be worth documenting *exactly* what you do and in exactly what order and then someone else can see if they can reproduce it and perhaps the problem could be fixed in a future release. I dont think it's a show stopper though...
--
Sync
Sync